Rules of application
German terminal blocks can be used to connect wires made of different materials and different cross-sections. They are especially convenient when performing electrical installation work in cramped conditions,
as well as in situations where the oman email list 2.7 million contact leads accessible part of the cable is too short.
When working with VAGA connectors, be sure to check the phase and also adhere to the following recommendations:
This requirement from Strip the cable insulation
To the recommended length. is based on technical calculations and safety parameters. The length of the stripped tip is calculated taking
into account that part of the wire in the terminal block is insulated. This will protect the contact from external influences and prevent electric shock.
There should be no oxide film artificial intelligence applied to retail on the wires to be connected. Therefore, it is recommended to remove the insulation from them immediately before connecting. If this is impossible or impractical, it is necessary to remove the oxide film. Its presence significantly worsens the quality of contact and can cause overheating and sparking.
Clamping devices with paste are intended for single use only
The cable is simply inserted into a special hole, after which it is impossible to remove it without destroying the contact or terminal device. Even if you inserted the wire and immediately noticed that you did it incorrectly, you will have to mobile lead completely redo the contact. To do this, you need to remove or cut the wire, strip it again, and then use a new connector. Even if the old terminal block looks good on the outside, some paste was removed from it during the process of removing the wire. Therefore, it is not suitable for reuse.
If you need to connect rigid cables This requirement from
With a large cross-section, it is recommended to use plates to unload the bundle. This will protect the created contact from subsequent “loosening”. When installing electrical networks up to 10 Amperes, which use standard sockets, switches, lighting devices, the use of additional limiters or protective devices is not necessary.
